With CC3D, just configure the Main Port as SBUS and you have a direct connection with 3 wires only All you need is a direct connection between FC and RX pretty much like PPM. Using X4R-SB (SBUS) on CC3D, Sparky, SPRacing, Dodo, Tornado For all these flight controllers (CC3D, Sparky, SPRacing, Dodo, Tornado), setup is very simple.Wenn ich die Sticks der Fernsteuerung bewege flackert manchmal kurz der entsprechende Channel z.B Input Channel 2 durch. Nachdem ich den FC in LibrePilot für SBUS konfiguriert habe, erschien im Input-Fenster konstant Input Channel 18. Ich habe dann den Walkera RX-Sbus gekauft und mit dem mitgelieferten Kabel mit dem CC3D-Atom verbunden (SBUS).You'll need to flash cc3d bin file in Open Pilot first then go to CleanFlight. Betaflight 2.1.3 fw flashed to CC3D clone. How to: SBUS with CC3D (Betaflight) & X4R / X6R / X8R In this video I show how I wired a S BUS connector that will work to connect a CC3D, REVO, or Atom board to a Frsky X8R receiver.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |